Shure ULXS24/58 Handheld Wireless System
Shure ULXS24/58 Handheld Wireless System
-70% Off$23,415.90
Description
Buy Shure ULXS24/58 Handheld Wireless System online in India – India’s music equipment superstore.
Shure ULXS24/58 Handheld Wireless System
The Shure ULXS24/58 system represents a breakthrough in performance and price for both working musicians and professional sound installers. Multiple system configurations provide limitless options, each with a choice of legendary Shure microphone transmitters. Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel.
Shure ULXS24/58 Features:
- Automatic Frequency Selection
- Over 1400 selectable frequencies
- Predictive Diversity
- RF presence LED
- 5’segment audio meter
- 3’segment transmitter battery fuel gauge
- Multifunction LCD
- 1/2 rack design
- Detachable 1/4 wave antennas
- Durable plastic chassis
- Locking DC connector
- XLR and 1/4 in. outputs
- Mic/line switchable.
Shure ULXS24/58 Specifications:
- RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
- used). Refer to the frequency supplement supplied with the system.
- Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
- Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
- ULX2 Transmitter Input
- Input Configuration: Unbalanced, active
- Actual Impedance: 20 kohms
- Maximum Input Level: 10 Vp—p (12 dBV) for 1% THD at minimum gain setting using 1 kHz signal.
- ULX2 Transmitter Output
- Actual Impedance: 50 Ohms
- Nominal Output Level: 20 mW
- Maximum Output Level: 30 mW
- Pin Assignments: Shell = Ground Center = Signal
- ULXS4 Receiver Input
- Connector: Antenna Power Input
- Connector Type: BNC IEC 320
- Actual Impedance: 50 Ohms
- Nominal Input Level: —95 to —30 dBm 15 Vdc
- Maximum Input Level: +6 dBm (—20 dBm recommended) 18 Vdc
- Pin Assignments: Shell = Ground Center = Signal IEC Standard
- Voltage for Remote Power: 12 Vdc, 150 mA maximum
- ULXS4 Receiver Output
- Connector: High Z Audio; Low Z Audio
- Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
- Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
- Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
- Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
- Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
- voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
- Transmitter Gain Adjustment Range: ULX2: 25 dB
- Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
- XLR connector (into 600 ohm load): +3.9 dBV (line), —17 dBV (mic)
- 1/4 inch connector (into 3000 ohm load): —2 dBV
- Impedance
- ULX1 (input): 1 Megohm ULXS4, ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
- Modulation: ± 38 kHz deviation compressor-expander system with pre- and de-emphasis.
- RF Power Output: ULX2: 30 mW maximum
- Dynamic Range: >100 dB, A-weighted
- RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
- Image Rejection: 80 dB typical
- Spurious Rejection: 75 dB typical
- Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
- System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
- Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 – 18 Vdc (negative ground), 550 mA
- Battery Life: 8 to 9 hours (with 9V alkaline battery)
- Operating Temperature Range: – 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
- NOTE: Battery characteristics may limit this range.
- ULX4S Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.52 in. (43 mm x 214 mm x 163 mm)
- ULXS4 Weight : 2 lbs, 5 oz. (1049 g)
- ULX2/SM58 Dimensions (Length x diameter): 9 x 2 in (228.6 x 51 mm)
- ULX2/58 Weight: 10.2 oz. (289 g) without battery
- SM58 Vocal Microphone
- Type: Dynamic (moving coil)
- Frequency Response: 50 to 15,000 Hz
- Polar Pattern: Unidirectional (cardioid), rotationally symmetrical about microphone axis, uniform with frequency
- Sensitivity (at 1,000 Hz Open Circuit Voltage): -54.5 dBV/Pa (1.85 mV)
- 1 Pa = 94 dB SPL
- Impedance: Rated impedance is 150 ohms (300 ohms actual) for connection to microphone inputs rated low impedance
- Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3
- Connector: Three-pin professional audio connector (male XLR type).
Made in China